Editing 3D Printer (section)

====BL Touch====
* [https://3dprinting.stackexchange.com/questions/11684/how-do-i-speed-up-the-bltouch-auto-bed-leveling-in-th3ds-unified-firmware speeding up bltouch]
* [https://www.youtube.com/watch?v=6oWNb2hVEhI Stuff]
* [https://www.reddit.com/r/Creality/comments/ljqbp9/ender_6_bltouch_31_how_to_adjust_zoffset/ Ender 6 + bltouch 3.1 - how to adjust z-offset?]
* [https://youtu.be/6oWNb2hVEhI?t=564 BL Touch 3.1] installed on Ender 6
* [https://www.reddit.com/r/ender6/comments/p09e7j/need_help_wiring_bltouch_loud_whirring_noise_when/ bltouch stuff]
* "The BLtouch v3.1 does not work well with the ender 6. A special kit for the ender 6 is available from Creality.
I think it's a V2.0 and I very rarely have any problems with it, very occasionally the pin shoots in before it hits the bed.
But with the reboot, the problem is immediately solved.
In your case there is a problem with the voltage which I read before, that should be 5V instead of the supplied 3.3V.
Because it doesn't get enough voltage, it can just stop.

It is also recommended to adjust the offset of the bltouch relative to the nozzle with M851.
If you don't know how to do this, I can send you an eeprom file with the probe offset!
Without the correct offset, the bltouch measures next to the nozzle and therefore does not print accurately in the Z axis."