Editing Electronics (section)

=PCB Etching=
* [http://www.instructables.com/id/Stop-using-Ferric-Chloride-etchant!--A-better-etc/ Better then Ferric Chloride] - Hydrochloric Acid (Muriatic Acid) - ~31.45%, %10 might be ok too... hydrogen peroxide, 3%... Also need Acetone for removing stuff afterwards...
* [http://www.instructables.com/id/Is-the-best-PCB-etchant-in-every-kitchen-/ hydrogen-peroxide, vinegar & salt]
* [https://www.youtube.com/watch?v=43Xsh9J7S-g Make Ferric Chloride] - Make Ferric Chloride from Iron (old rusty nails) 100mL of water and 100mL of 12M hydrochloric acid. Once the ferrous chloride solution is made it needs to be oxidized to ferric chloride. The fast way of doing this is to add 200mL of 3% hydrogen peroxide.
* [http://www.instructables.com/id/The-Saltwater-etch-process/step13/Draw-around-the-pads-with-a-sharp-instrument/ Marker and Saltwater] - Inverse boards. Remove only the bit's you don't want connected...
* [http://www.ebay.com.au/itm/PCB-Etching-Kit-to-etch-a-circuit-board-New-/262403095846?hash=item3d18717d26:g:A2EAAOSwEzxYTG8W This Kit] - "100g Sachet of Sodium Persulphate etchant", "Positive Developer for Riston"
* [https://web.archive.org/web/20060822061531/http://members.optusnet.com.au/~eseychell/PCB/etching_CuCl/index.html Etching with Air Regenerated Acid Cupric Chloride] - Science!
* [http://www.opencircuits.com/Chemical_Etchants] - This site.
* [https://www.youtube.com/watch?v=HBIxvwZ_0og Heatless (cold) Toner Transfer (for PCB)] - Asatone+Ethanol
* [https://hackaday.com/2012/12/10/10-ways-to-etch-pcbs-at-home/ NurdRage]
* [https://www.youtube.com/watch?annotation_id=annotation_614533555&feature=iv&src_vid=Rf5HBLzDGQA&v=rj4qe6bdu7k Glass boards]
* [https://www.youtube.com/watch?v=mwwA1d2s2OQ No-etch circuit boards with your laser printer] - Silver Adhesive directly on toner.
* [https://www.youtube.com/watch?v=sNh0ubRcTYU 3D printer etching]
* [http://forum.allaboutcircuits.com/threads/project-photographic-methods-of-making-pcbs.107696/ PCB UV Info]

==Protoboarding==
* [http://www.instructables.com/id/How-to-Prototype-Without-Using-Printed-Circuit-Boa/step4/Connect-the-components-using-Kynar-wire/ how to]
* [https://www.sparkfun.com/products/12070 This sparkfun solderable breadboard seems neat (but too expensive...)]