Editing 3D Printer (section)

==TODO==
* More robust Z_ADJUST. Store variable in config, or find a way to get it live. [https://www.reddit.com/r/klippers/comments/rzwiry/is_there_a_better_way_to_do_this_auto_adjust_z/ if statement]
* [https://www.reddit.com/r/klippers/comments/wkgyg4/favourite_klipper_macro/ Favourite Klipper Macro] - Bed Mesh only on Print area
* [https://www.youtube.com/c/MirageC/videos 3D Printer Hotend Olympics]
* [https://github.com/hartk1213/MISC/tree/main/Voron%20Mods/SuperSlicer SuperSlicer bed model/textures]
* <strike>Calibrate Z adjust</strike>
* Maybe make Z adjust depend on temperate
* Calibrate acceleration
* [https://www.ebay.com.au/itm/303978783939?hash=item46c68c24c3:g:niMAAOSwuFVgipwc&amdata=enc%3AAQAHAAAA4FVTFOmy7kK4UY1gB0LAVvKrd6Lx9P2H5ZpAJrrBJyroDyTJ1n%2FrnlyMBnkO0uE2Mj6FB7zWfcLUMRy7%2FfmecWAuXYTMVpr1WjdyDt17YAR8C6lHYcw%2B5G1yMLV0vssFw%2BTQgFg6Vyg8L3lFTykrQ%2BoLcMAxgvX9tiCabyAPxVW267nIcwP7gLiK7qP5DSaY6mXb42yJy0XOvw24UurGjA%2Fyuf02L5RHWpQA6OWl2uLJpqSqUfaCErQOSjQmqdd%2F%2F4hu4EksSnrw3UDOu6jEIw5ye7UVpr4aAhBzto%2FPO8Yh%7Ctkp%3ABFBMnrKFwLFg Surface thermocouple K type high temperature resistance Probe] (Need to crimp bannana plug for multimeter)
* <strike>Crimp BIQU H2 Cables</strike>
** <strike>Control cable</strike>
** <strike>Thermister</strike>
** <strike>Hotend cables.</strike>
* <strike>Crimp new Sunon fan cables</strike>
* <strike>Tighten heater block/nozzle at temperature</strike>
* <strike>PID Auto Tune</strike>
* <strike>Calibrate probe offset position in Klipper config.</strike>
* Calibrate thermistor.
* Check accelerometer pins.
* Solder molex headers onto accelerometer (if fits).
* Crimp accelerator cable (ethernet).
* <strike>Do resonance canceling</strike>
* <strike>Do input shaper</strike>
* Redo bed leveling sensor cable so it terminates at the print head not down the chain.
* <strike>Heatset inserts for BIQU H2 fan mount bracket</strike>
* <strike>Set esteps/rotation for BIQU H2</strike> (the defaults where good)
* <strike>Set START_GCODE macro to put into slicers. (CURA: Make bed temp full when idle, don't lower platform all the way when done, don't purge line in dead space).</strike>
* <strike>Add line to update display to slicers</strike>
* Setup color changing macro (added but untested...)
* <strike>Make proper camera mount</strike>
* Add LEDs
* Move Y Axis limit switch back
* Tension belts