Buy: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 11: | Line 11: | ||
==Electronics== |
==Electronics== |
||
[http://reprap-diy.com/gen7_board-arm_2.0#components RepRap Gen7 Electronics] |
|||
| ⚫ | |||
| ⚫ | |||
* Photodiodes |
* Photodiodes |
||
* Nicromium Wire |
* Nicromium Wire |
||
Revision as of 16:37, 27 August 2016
Tools on dx.com
- Centre Punch
- Mitre Box.
- Dial guage?
- Try Square. (Right Angle)
- Dowling Tool (for right angle drilling).
Molding/Casting
- Transparent Silicon
Electronics
* 2x Wireless modules. ESP8266 ESP-03, About $3 on ebay. (Remember to look up voltage divider). Need USB Serial programmer, FTDI with 3.3v support.
- Photodiodes
- Nicromium Wire
- Tiny stepper motors (5 are like $4)
- Transistor/Capacitor tester ($12)
- DIY Oscilloscope DSO138 (preassembled with case for $30) - http://www.banggood.com/search/dso138.html + USB TTL (Or make an Arduino/soundcard one).
- DC-DC stepdown powersupply $7
3D Printer
- Casting Resin
- 2.3kg of Hydrocal is about $75, 100 pounds hcal to 45 water
- 4x Stepper Motors - NUMA 17
- Filament
- Hot Head
- Extruder